If you have a dog that likes to bark, and particularly if your dog loves to play in the backyard and other areas of the house, you need to get them some special dog protection.
Paper Plate 3d Dog Mask DIY Materials: This is the initial part of the setup which will look a little scary at first, but it’s really very straightforward. All you have to do is take a cardboard cutting board and cut the cardboard into the shape of your mask. You can not just cut a rectangular shape out of the cardboard, so you’ll have to cut around the edge of the mask so that you get something that looks like a cone. The most important thing here is to be realistic with what type of paper plate which you’re using.
Then you’ll have to wrap the cardboard around the edges of the paper plate, making sure that there is a good seal between the two pieces so that you can make certain that nothing will leak once you put the mask on. Be sure the edges are cut so the edges are not sharp, as this may damage the edges of the mask.
Glue it on! The next step involves using some paint. You ought to spray the paint over the cardboard, making sure that it runs smoothly and evenly across the entire mask. You’ll want to start with one side of the mask , so that you can work your way around it before moving onto the other side. The paint needs to be slightly thicker than the cardboard, and it is best that you leave about one-third of an inch of paint on the edges so that it runs across the cardboard.
Don’t worry too much about the paint getting stuck into your mask. It’s easy to remove it later, and it will leave you with a nice finished mask to show off to everybody! It’s also a good idea to wash away any excess paint after you’re done, so that you don’t end up with smudges or smears on your dog.
Then it is time to glue the mask on your dog’s head. First you need to make sure that you have a secure fit between the mask and your dog’s head. As soon as you’ve made sure that it’s secure, then you may begin to glue the mask on the dog’s face. Take the piece of cardboard that’s used for the foundation of puppy dog mask the mask and fold it over. Make certain it’s quite powerful and then use your hands to ensure the cardboard down in place.
Keep your hands out of the way and use tape to hold it in place as you repeat the process on the cardboard folds until you’ve got the mask snugged firmly onto the face of your dog. Do not make the folds too large or else it could look messy. Once you’ve done this, you can then take out the mask and then attach the cardboard ears. And attach the other part of the mask onto the dog. Be sure that the ears are level and be certain it is not too short or long as this can cause some problems with the mask slipping off the dog’s face.
If you are using a dog mask as your dog protection, you’ll have to do some sanding to make certain it’s safe on your dog. You can accomplish it by sanding off any excess paper which might have been removed from your mask.